OPERATION

XTBA Smart Merge will multiplex two DMX512 input signals to a single DMX512 output signal. Each dimmer channel from the two input signals is compared and the higher channel level will be outputted. The second DMX input's start address may be altered by setting the offset address on the three front panel code switches.

The two DMX512 signals to be merged are connected to inputs one and two. The output is connected to DMX512 out and to the equipment to be controlled. Input one will pass the DMX data straight through the unit. Input two allows for the input start address to be moved relative to input one.

When power is applied to the unit the green SYSTEM OK LED will flash. When valid DMX512 data is being received the input channel yellow LED will light. If the data is not DMX512 or invalid, the channel yellow LED will flash.

By use if the three code switches on the front panel it is possible to move the start address of input two. This will prove to be most useful when two control systems need to be joined together e.g. a lighting control and a moving light control. If the lighting control for example has 250 channels, by setting the address on the front panel to 251 channel one/input two will appear at 251 on the merged DMX output. Any overlapping channels will be treated as highest takes precedent e.g. the highest value will be outputted.

OFFSET ERROR

If the address switches are set to any number above 512 the OFFSET ERROR light will flash.  

POWER SUPPLY

The mains input to the transformer is via a 2A a/s fuse and the transformer may be switched to 120 volt operation via on board switch. A spare fuse is provided in the input connector block on the rack unit.

19” RACK MOUNTING

The XTBA Smart Merge is provided with a pair of ‘ears’ for fitting into a 19” rack frame. The ears are fitted to the unit by removing the two screws on either side at the front of the unit. The stick on rubber feet (used when the unit is free standing) will need to be removed from the underside of the unit.

Technical Specifications

19” Rack, Front or Rear connectors

Dimensions 260 (295mm inc.front handles) x 430mm x 32mm

Weight 4.0 Kg

Power  190/250V AC Nominal 2A 240V AC

Data DMX512 1986/1990

Pin Configuration& Pin 1 Common, Pin 2 minus data, Pin 3 plus data.

Pins 4 and 5 are not connected.

General Information

This product may only be used for controlling dimmers and moving lights. It must not be used in DMX512 applications for stage machinery or pyrotechnics. Using the product out of these specifications will remove all responsibility from the supplier.

CE Declaration of conformity

XTBA declares that the following equipment meets the requirements of the EMC Directive 89/366/EEC.

ISSUE B 17/12/01