XTBA

Decoders

DMX to analogue decoders are still to be found in numerous theatres and TV stations around the world. The ideal (and in many cases the only) way to interface older dimmers to DMX - oh happy days of multicore cable, Socapex and the pin matrix!

A while ago XTBA installed 1,632 channels of DMX to analogue decoders in a TV studio. Some years later they needed some splitters but did not know of XTBA - until it was pointed out to them that they had two racks with 34 XTBA decoders in the basement. They had switched these on and forgotten about them for six years - they then bought the splitters from us without further hesitation!

8 way DMX to Analogue DIN Rail

Works with:



Product Number: 
05901

Further information:





*Now upgraded to include fully enabled RDM and with added features such as emergency mode and grouping.

A mains powered DIN rail mounted 8 channel 0 to +10V decoder. Channels can be set into two groups of four or individual channels set as non dims. Emergency mode allows all outputs to fade to a predetermined level in the event of DMX loss. 
Local output test mode from the address switches. RDM enabled.

Output 0 to +10V DC. Individual outputs can also be set to act as non dims.

9 DIN Module, Width = 157mm, power & data leds, DMX address switches

Specifications:

Dimensions



Supply voltage



Packaging


Colour

DMX8 Decoder PCB RDM

Works with:



Product Number: 
09405

Further information:





*Now upgraded to include fully enabled RDM and with added features such as emergency mode and grouping.

A PCB 8 channel 0 to +10V decoder for upgrading existing analogue systems or interfacing to DMX. Channels can be set into two groups of four or individual channels set as non dims. Emergency mode allows all outputs to fade to a predetermined level in the event of DMX loss. Local output test mode from the address switches. RDM enabled.

Eight analogue channels are available via the HE14 / Molex connector.

Specifications:

Dimensions



Supply voltage



Packaging


Colour

DMX1 Decoder PCB

Works with:



Product Number: 
09403

Further information:





A one channel DMX to analogue 0-10v +V converter on a PCB.

The unit has an additional open collector switch which will be turned on if the selected channel level is above 10%. This feature allows the card to be used with fluorescent ballasts etc.

Includes BCDs and LEDs.

Displays for power / card OK and data. 

Specifications:

Dimensions



Supply voltage



Packaging


Colour